InstallAware

Outside of what's on the internet, any thoughts on how to make a service run?

It installs with ease---but fails to start.

When I manually install the service, it works without a problem.


Thanks!

Dear Stanzo,

please don't post multiple times the same question.

By the information you shared, it's not easy from here to find out what are the cause of your issue.
I can only suppose that you are not issuing the service command correctly.

Could you post a very very minimal project that replicates your issue (along with all the files used)? I'll try to verify it.

BTW, did you try the sample available with the link http://www.installaware.com/forum/viewtopic.php?f=2&t=5819?
The sample demonstrates how to install a service, did you see any difference with the approch you used?

Regards