Running an application within the installer causes issue in maintenance mode
Posted: Thu Aug 16, 2018 2:16 pm
Hi guys,
I run a .exe file towards the end of my application, and it works fine when I do fresh install.
But when I do a maintenance install after that (using change option in control panel), after my installer runs that executable and completes, user cannot open any installer from programs and features page.
It looks like it thinks the executable I am running is a part of installer, and it displays this error, unless I close that executable:
"Please wait until the current program is finished uninstalling or being changed"
Please let me know if there is any other way of running an application from installer, that does not cause this issue after install completes in maintenance mode.
Thanks,
Mehran
I run a .exe file towards the end of my application, and it works fine when I do fresh install.
But when I do a maintenance install after that (using change option in control panel), after my installer runs that executable and completes, user cannot open any installer from programs and features page.
It looks like it thinks the executable I am running is a part of installer, and it displays this error, unless I close that executable:
"Please wait until the current program is finished uninstalling or being changed"
Please let me know if there is any other way of running an application from installer, that does not cause this issue after install completes in maintenance mode.
Thanks,
Mehran