Page 2 of 2
Posted: Wed Dec 07, 2005 11:16 am
by sinan
Now, Final Beta is available at the same download locations referenced above. Enjoy!
Changes to final?
Posted: Wed Dec 07, 2005 11:32 am
by ecold
Is this just bug fixes or is there anything new?
Posted: Wed Dec 07, 2005 12:27 pm
by sinan
Bug fixes (important ones), new setup theme.
Update issues.
Posted: Wed Dec 07, 2005 1:29 pm
by ecold
It would appear that installing the update, removes any existing projects. That really hurts. So, I tried to import my Group Policy msi file I made, I get this nice error message that says: " is not a valid integer value.
Then, it fails.
Am I going to have to start from scratch to redo my project that has taken me 50 or so hours to get almost right?
What little does come through
Posted: Wed Dec 07, 2005 1:37 pm
by ecold
When clicking the sections of the interface of what little was pulled in by the import, I get that popup again when I click the Registry button. Just FYI.
I'm feeling really sick right now.
Posted: Wed Dec 07, 2005 5:34 pm
by sinan
The update does not remove any of your projects, that would be ridiculous!
Where had you saved your files?
Posted: Wed Dec 07, 2005 5:35 pm
by sinan
Also, which file did you import, and where do you get errors with the imported file?
I have the compiled files but not the project mpr
Posted: Thu Dec 08, 2005 8:36 am
by ecold
I had saved it where the final installable was or at least a few directories above it and it's not there. I have searched my whole computer and network shares just in case I put it somewhere else and it's not there.
I have a single file .exe that was created. It doesn't seem to import those. I had used the Group Policy Wizard to make an msi from the single exe and imported it. It is the one that is erroring out. When I went to open it just now, I got the same error " is not a valid integer value.
If I navigate through the UI, I get the error when i click the registry button.
I found an older version of it
Posted: Thu Dec 08, 2005 8:47 am
by ecold
It was in a different project folder on a network share. I had to go to the admin share and search in order for it to show up. That doesn't make sens but, I'll I care is I got it back.
There still may be a bug in the import however but right now, I'm not worried about it. Sorry for the scare but it's not where it should have been and then I couldn't find it on any drive searches.
Posted: Thu Dec 08, 2005 1:03 pm
by sinan
I have confirmed the import issue, thanks for reporting it. Its in the hands of the product team now!
Glad I could help
Posted: Thu Dec 08, 2005 1:28 pm
by ecold
I'm glad it wasn't a complete waste of time, typing and reading for us both. Glad I could contribute something.