InstallAware

Posted: **Thu May 22, 2008 9:21 am**

If at uninstall time I want to remove any unpinned assemblies that my installer placed in the GAC, what is the preferred means? Do I just add the command immediately after "Apply Uninstall", or should I check the value of the SUCCESS variable before running the command?

Should I do this

Code: Select all

  Apply Uninstall (get result into variable SUCCESS)
  if Variable SUCCESS not Equals ERROR
    if Variable SUCCESS not Equals CANCEL
      Remove Unpinned Assemblies
    end
  end

or is this enough?

Code: Select all

  Apply Uninstall (get result into variable SUCCESS)
  Remove Unpinned Assemblies

Posted: **Thu May 22, 2008 1:40 pm**

Chris,

I would do it the first way, that way you will make sure the user did not cancel the uninstallation, and that there wasn't any error in the process.

InstallAware

What is the proper way to use Remove Assemblies?

What is the proper way to use Remove Assemblies?