Page 1 of 1
Maintenance dialog, when chosing remove $REMOVE$ is not set
Posted: Tue Nov 03, 2009 9:07 am
by joltman
Hi, we are facing a problem with the maintenance dialog, if the user chooses to remove the application the variable $REMOVE$ does not get set.
We need this in the next dialog to display message such as "setup is now ready to UNINSTALL application XXX"
Any ideas?
Posted: Wed Nov 04, 2009 5:07 pm
by neillans
Check the logic applied to the controls on the page (double click the controls on the form in the designer!), and see what is configured.
Also, have you tried adding watches and stepping through?
Posted: Thu Nov 05, 2009 3:11 am
by joltman
Hi,that was the first thing i looked at it writes to remove variable.
Posted: Mon Nov 09, 2009 4:59 pm
by neillans
Care to submit your project for us to have a look?
Posted: Tue Nov 10, 2009 8:45 am
by joltman
Im sorry but I can not do that due corporate restrictions.
neillans wrote:Care to submit your project for us to have a look?
Posted: Thu Nov 12, 2009 5:19 pm
by neillans
How about building a sample project for us? Without something to look at our assistance ability is going to be limited.