InstallAware 9 to 9.02

SimonTemlett · Post by **SimonTemlett** » Fri Jun 05, 2009 8:41 am

I want to update my InstallAware installation from 9 to 9.02.

I've downloaded the trial, done the install and run the licensing.

All ok.

However I chose to perform the minimum install because I already have the 1.2Gb of runtimes already sat on my harddisk. If I go into Control Panel and Change InstallAware installation it seems to want to go and download all the files again.

How do I get the installer to look at my harddisk for the runtimes?

Simon

MichaelNesmith · Post by **MichaelNesmith** » Sun Jun 07, 2009 5:46 am

When you do a minimum install, no runtimes are installed. So you have to do a complete install.

SimonTemlett · Post by **SimonTemlett** » Mon Jun 08, 2009 3:17 am

I understand that but if I choose full install, do I have to download 1.2Gb of runtimes when I already have them on my hard disk?

MichaelNesmith · Post by **MichaelNesmith** » Mon Jun 08, 2009 6:08 am

You should - the latest 9.03 update has some new files across the board.