InstallAware v5.0 Public Beta

Postby **sinan** » Wed Dec 07, 2005 11:16 am

Now, Final Beta is available at the same download locations referenced above. Enjoy!

ecold · Postby **ecold** » Wed Dec 07, 2005 11:32 am

Is this just bug fixes or is there anything new?

Postby **sinan** » Wed Dec 07, 2005 12:27 pm

Bug fixes (important ones), new setup theme.

ecold · Postby **ecold** » Wed Dec 07, 2005 1:29 pm

It would appear that installing the update, removes any existing projects. That really hurts. So, I tried to import my Group Policy msi file I made, I get this nice error message that says: " is not a valid integer value.
Then, it fails.
Am I going to have to start from scratch to redo my project that has taken me 50 or so hours to get almost right?

ecold · Postby **ecold** » Wed Dec 07, 2005 1:37 pm

When clicking the sections of the interface of what little was pulled in by the import, I get that popup again when I click the Registry button. Just FYI.
I'm feeling really sick right now.

Postby **sinan** » Wed Dec 07, 2005 5:34 pm

The update does not remove any of your projects, that would be ridiculous!
Where had you saved your files?

Postby **sinan** » Wed Dec 07, 2005 5:35 pm

Also, which file did you import, and where do you get errors with the imported file?

ecold · Postby **ecold** » Thu Dec 08, 2005 8:36 am

I had saved it where the final installable was or at least a few directories above it and it's not there. I have searched my whole computer and network shares just in case I put it somewhere else and it's not there.
I have a single file .exe that was created. It doesn't seem to import those. I had used the Group Policy Wizard to make an msi from the single exe and imported it. It is the one that is erroring out. When I went to open it just now, I got the same error " is not a valid integer value.
If I navigate through the UI, I get the error when i click the registry button.

ecold · Postby **ecold** » Thu Dec 08, 2005 8:47 am

It was in a different project folder on a network share. I had to go to the admin share and search in order for it to show up. That doesn't make sens but, I'll I care is I got it back.
There still may be a bug in the import however but right now, I'm not worried about it. Sorry for the scare but it's not where it should have been and then I couldn't find it on any drive searches.