I have a finish form that has a couple of check boxes on it. I have added a new check box to it, and have set the default checked status to true. I save and test in the editor, and the checkbox works as it should. When I run my installer, the checkbox never shows that it is checked by default. It always appears as unchecked.
Can you tell me where I should be looking to troubleshoot this? There seems to be more logic going on it the form than the logic that is visible or accessible in the designer.
Got a problem you cannot solve? Try here.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 25 guests