if i look "finish" dialog preview i see "Reboot computer now" check, but i don't see where enable it: the compiled project show me only "Run MyProgram now" check. Can anyone help me ?
If the Apply Install command sets the SUCCESS variable to REBOOT, the dialog will display the Reboot Now checkbox. Of course, this is jut the default behavior in the setup scripts. You may customize it as you see fit.
sinan wrote:If the Apply Install command sets the SUCCESS variable to REBOOT, the dialog will display the Reboot Now checkbox. Of course, this is jut the default behavior in the setup scripts. You may customize it as you see fit.
