Installing in the GAC WITH Com Interop

[TMacy]

This is not quite the same as addressed in the sticky post.

I want to install into the GAC, and to register the component for COM Interop. Other solutions that I have evaluated have this as an option. Does 7.x support this? If not, how do you suggest we do it? Running Regasm as a program requires a copy of the assembly outside of the GAC, right?

[rickrat]

This is not quite the same as addressed in the sticky post.

I want to install into the GAC, and to register the component for COM Interop. Other solutions that I have evaluated have this as an option. Does 7.x support this? If not, how do you suggest we do it? Running Regasm as a program requires a copy of the assembly outside of the GAC, right?

I am unsure of whether it has to be outside of the GAC, but it's likely. Install it to the normal dir and the GAC. Won't harm anything.

[TMacy]

I'm migrating off of a very old version of Wise that has no knowledge of .Net. In that solution, we install to a temporary folder, run regasm, run gacutil, and then blow away the temporary folder.

That works. Was hoping there was something that was just a point and click