Maintenance dialog, when chosing remove $REMOVE$ is not set

joltman · Post by **joltman** » Tue Nov 03, 2009 9:07 am

Hi, we are facing a problem with the maintenance dialog, if the user chooses to remove the application the variable $REMOVE$ does not get set.

We need this in the next dialog to display message such as "setup is now ready to UNINSTALL application XXX"

Any ideas?

neillans · Post by **neillans** » Wed Nov 04, 2009 5:07 pm

Check the logic applied to the controls on the page (double click the controls on the form in the designer!), and see what is configured.

Also, have you tried adding watches and stepping through?

joltman · Post by **joltman** » Thu Nov 05, 2009 3:11 am

Hi,that was the first thing i looked at it writes to remove variable.

neillans · Post by **neillans** » Mon Nov 09, 2009 4:59 pm

Care to submit your project for us to have a look?

joltman · Post by **joltman** » Tue Nov 10, 2009 8:45 am

Im sorry but I can not do that due corporate restrictions.

neillans wrote:Care to submit your project for us to have a look?

neillans · Post by **neillans** » Thu Nov 12, 2009 5:19 pm

How about building a sample project for us? Without something to look at our assistance ability is going to be limited.