Unable to compile MSI Action set registry entry

[Frank]

My installer writes a couple of value into the registry. This has been working fine, but now all of a sudden the script no longer compiles.
I get the message ' Unable to compile MSI Action set registry entry'. So I started looking at the Write Registry entries.

Code: Select all

Write Registry Key HKUD\\Software\Write Registry Key HKUD\\Software\\Microsoft\Write Registry Key HKUD\\Software\\Microsoft\\Windows
Write Registry Key HKUD\\Software\\Microsoft\\Windows\\CurrentVersion\Write Registry Key HKUD\\Software\\Microsoft\\Windows\\CurrentVersion\\Internet Settings\\ 
Write Registry Key HKUD\\Software\\Microsoft\\Windows\\CurrentVersion\\Internet Settings\\Zones
Write Registry Key HKUD\\Software\\Microsoft\\Windows\\CurrentVersion\\Internet Settings\\Zones\\2
Write Registry Key HKUD\\Software\\Microsoft\\Windows\\CurrentVersion\\Internet Settings\\Zones\\3
and more....

I disabled all HKUD lines and the script compiles again.
I can enable

Code: Select all

Write Registry Key HKUD\\Software\\

and it compiles
if I also enable

Code: Select all

Write Registry Key HKUD\\Software\\Microsoft\\

it doesn't compile.

What is going on? Did I change (perhaps) a project setting? It only happens when dealing with HKUD. I can write to any other hive.

Remember up till 10 minutes agom nothing was going on. I've had this problem earlier today. I exited IA9 and didn't save the project files, after reopening them it all worked.
Now, I can go back to source control and retrieve the earlier verion, but I'll lose all my hard work

[Frank]

I retrieved the old source and it compiles again!

I've compared (using .mia.txt) the changes and the only relevant changes is the usage of $SERVERNAME$ inside the Write Registry Key.

Maybe it's relevant maybe it's not!

I'm using this $SERVERNAME$ in both HKUD and HKCU. Only the HKUD seems to cause problems.
How can I make sure that IA is recompiling everything (the equivelant of Rebuild Solution in Visual Studio)?

[MichaelNesmith]

Hitting build should recompile everything. In general, you want to use the build button, and very rarely the compile button (except to check for syntactical correctness).

[Frank]

Thank you for the answer on my last question. I do remain curious as to what happened (twice) yesterday.
Why can (under unknown circumstances) the script stop compiling when writing HKUD. What if it happens again?

I still have copies of the mpr/mia files of the failing project, should I sent these and/or do you need more?