\"Configuration failed\" error

ogren · Post by **ogren** » Thu Dec 14, 2006 10:10 am

I have built the installation package and it works fine in debug build. But if I run it in release build all I'll see is a message box titled "InstallAware Wizard" with message "Configuration failed".

This message box shows up before the first script line (I tested to put a message box as the first line and it never shows up).

There is nothing about this in the help (I searched for "Configuration failed"), and I can't find it in this forum or elsewhere on the Internet.

MichaelNesmith · Post by **MichaelNesmith** » Thu Dec 14, 2006 1:58 pm

I think this might be an issue with the initial setup decompressor stub. Would be great if you could send us your project, so we can take a look at it and resolve. We'll need the full project folder (without subfolders or actual build files) in this case.

ogren · Post by **ogren** » Fri Dec 15, 2006 3:27 am

Thanks for the answer.

I fixed the problem by starting a new project and copying all dialogs and script rows. Sorry, but I have already deleted the old project.

MichaelNesmith · Post by **MichaelNesmith** » Fri Dec 15, 2006 2:42 pm

No problem - just please post back if you see anything!