silent install switches

pumagaju · Post by **pumagaju** » Wed Feb 21, 2007 3:23 pm

I have an InstallAware wrapped EXE that I need to deploy via Altiris. But I'm having trouble finding the switches to run in silent mode.

Also would like to know if I can easily enter license key info the same sorta way that InstallShield works with setup.iss files.

Thanks in advance,

H4nd0 · Post by **H4nd0** » Thu Feb 22, 2007 7:28 am

In the IA 6.24 CHM help ... look for Setup Command Line Parameters:

/s
/l
/k
/p

Plus you can pass variables on the CLI which you could potentially use for your licensing.

pumagaju · Post by **pumagaju** » Thu Feb 22, 2007 12:18 pm

Thanks for the pointer. I was able to use the logfile switch to create an initial logfile. Then I read the logfile to find the correct variable values I need to set, in this case LICENSE=.