Restart IIS

rlangham · Post by **rlangham** » Fri Jul 27, 2007 2:56 pm

I am needing to restart IIS after the install. I see that I can Stop and Stop a specific IIS, but is there a way to wait for the Stop to complete before doing a Start.

In previous install using another vendor's installation package (which I am desperately trying to get out of .. IS ), I would do a Start and Stop on the World Wide Web Service. I see that there are methods to Start and Stop service, so if I need to use this, then similar question, is there a way to know when Stop is done before doing Start.

Thanks,
Ron

MichaelNesmith · Post by **MichaelNesmith** » Fri Jul 27, 2007 5:37 pm

You can use the Run Program, command to run "net stop w3svc" and wait for the program to return before completion.