Return codes

[zchris]

We are using the new Terminate with Exit Code command to signal if a setup has failed. This works very well.

However it appears that if the setup cannot unpack itself (out of space, etc.) it will return 0 (SUCCESS).

Could you please verify this and change it to return an error code? Thanks!

[sinan]

Thanks for reporting this. I'll have this escalated and resolved.

[K-ballo]

zchris, could you just please tell us if you are doing a silent installation? That would help a lot. Thank you.

K-ballo.-

[zchris]

Yes, we are doing silent installs (with a few parameters if that matters). However in the script we set SILENT=FALSE and show only progress dialogs without a cancel button.

[K-ballo]

I forced the setup to unpack to a removable media with no free space, in both silence and non-silence ways, and both of the times I get a return code of 1.
Please, try to run the same setup but in non-silence mode, as you will get a message box with a description of the error, and post it here. Thank you.

[zchris]

Sorry for the late reply.

I haven't been able to produce this error again but I'll let you know when I have more information.

Thanks.