Unable to Debug

binkle · Post by **binkle** » Mon Sep 18, 2006 9:40 am

Hi,
I'm completely unable to debug.
Yes, I did switch my project to uncompressed output.
There are no variables in the outputpath. (standard)
The output filename ist just set fix tho "mysetup".

I set breakpoints on the line:

Code: Select all

if Variable WIZARD Equals CANCEL

of label: Welcome Dialog

and some other 'if' of dialogs.
I rebuild the setup and used the button with the nice '!', but the setup did not stop on thebreakpoint when the cancel button of the diaglog is pressed.

What am I doing wrong?

Tinus · Post by **Tinus** » Mon Sep 18, 2006 11:40 am

Harald,

I rebuild the setup and used the button with the nice '!',
but the setup did not stop on thebreakpoint when the cancel button of the diaglog is pressed.

Do not use the ! button, this will run your setup without debugging.

Use the green > button or press F9 to run with debugger.

jimo · Post by **jimo** » Mon Sep 18, 2006 11:42 am

Try the green arrow instead of the red exclamation mark.

binkle · Post by **binkle** » Tue Sep 19, 2006 1:50 am

Oh, I'm sorry,
Stupid me... should read the whole hint.

Thanks!