Strange Vista problem - Setup shows 'Error' but not on XP!

[fosnl]

Hi,

I built a setup that works just fine on Windows XP. On Vista it gives an error on the moment of the 'Apply Install' (Fatal error during installation)
Even when I modify the setup and actually remove everything from it still produces the error!
If I look in the eventlog I see an error 1013 in the MSIInstaller...
Anyone?

[MichaelNesmith]

Error 1013 is not covered in the MSDN documentation under Windows Installer errors.

In case it was 1310:

1310 Error attempting to create the destination file: [3]. System error code: [2]

[fosnl]

I'm sorry to say it is error 1013...

I stripped my whole setup and it is actually installing nothing anymore - and it still produces the error.

I'm running InstallAware Studio 6.6.

Can it be caused by the fact that my project was made in InstallAware 5, then modified in 6.0 and now modified en build in 6.6?
If so - maybe this is also the cause of the other problems I have and I posted in this newsgroup?

File Attached:

ErrorInEventlog.PNG

[fosnl]

The '1013' code is actually the eventid posted in the Eventlog...
If I look a few events later It shows that the Installation returned a '1603' code...

File Attached:

ActualErrorInEventlog.PNG

[BrandonK]

Michael,

What is the status of this bug? I'm now hitting this exact error on two different installs when tested against Vista. I'm running 6.6 (berlin_rtm.051507). Thanks.

[fosnl]

No idea, I had no response anymore from Installaware about this one.
Our project was built in version 5, then modified in 6.5 and later 6.6 when it gave the problem.
We just re-created a new project whith the same code and that one workes fine on Vista.
Frans Oskam